RD-Cement Mix

APPLICATION CONDITIONS:

Can be used with any hydraulic binder
• Unsaponifiable material;
• Environmentally friendly;
• Can be used as a primer or as an adhesion primer for cement grouts or plaster work on difficult to treat smooth surfaces such as concrete, smooth tiles, paint, glass, plastic and so one;
• As an insulating primer on any type of burnt areas, water spots, etc. which have to be filled, painted or plastered afterwards.

This should be done like this: make a dilution of 1 part of water and 1 part of RD-Cement Mix.
Apply until the surface feels sticky (not dry) and after this, apply the plaster immediately.

APPLICATION MEANS:

Flat brush or normal brush.

PARTICULARITIES:

RD-CEMENT FILLER mixed with RD-CEMENT MIX 20% shows an excellent brushability to make the walls of concrete tanks, water purification stations, collection tanks, concrete water channels etc. waterproof.

Procedure:

1. Substrate Preparation: As substrate, any type of porous concrete or masonry is suitable. Bad joints, cavities and damage must be filled first by means of RD-CEMENT FILLER (see technical data sheet) Metal which should be coated, pre-treat with RD-ELASTOMETAL.
The substrate should be supporting, clean, stripped of loose parts and may be dry or slightly humid, max. 5%. Remove hydrophobic rests such as oils, grease or ancient coats.

2. Finish:

Apply 1 coat of RD-CEMENT MIX diluted with 1 part water, so 1 on 1, on the concrete – Consumption: about 4 m²/L, depending on the porosity of the substrate.
Apply 2 coats of mixed RD-CEMENT FILLER with RD-CEMENT MIX by means of a flat or normal brush. Application of the second coat should be done after drying of the first one. Consumption: at least 2 kg of mixed product m².
In order to change the brushability, water may be added. Do not apply during bad weather conditions, abundant rain and risk of frost.

DRYING TIME (20°C - 68°F):

Touch dry: +/- 1h hour
Recoatable: +/- 4 hours

CLEANING OF TOOLS:

Water